Highland Supercell - Page 26

27
101: Converter electronics error – Low baery voltage
The baery voltage into the electronics is too low. The unit should be returned for service.
102: Converter electronics error – High baery voltage
The baery voltage into the electronics is too high. The unit should be returned for service.
103: Converter electronics error – High output voltage
The voltage out of the electronics is too high. The unit should be returned for service.
104: Converter electronics warning – Over current
The current out of the electronics is too high. The unit should be returned for service.
105: Converter electronics warning – Communicaons
The communicaons between the converter electronics and the microprocessor control have
broken down. The unit should be returned for service.
106: Converter electronics warning – Over temperature A
The temperature of the converter electronics phase A is too high. The unit should be returned
for service.
107: Converter electronics warning – Over temperature B
The temperature of the converter electronics phase B is too high. The unit should be returned
for service.
108: Converter electronics warning – Over temperature C
The temperature of the converter electronics phase C is too high. The unit should be returned
for service.
109: Converter electronics error – Phase current
The current in the converter electronics is out of specicaon. The unit should be returned for
service.
110: Converter electronics error – Relay open
The main control relay in the converter electronics is open circuit. The unit should be returned
for service.
112: Converter electronics error – Voltage sense open
The voltage sensing relay in the converter electronics is open circuit. The unit should be re-
turned for service.
113: Converter electronics warning – Peak me exceeded
The converter electronics ming circuit has broken. The unit should be returned for service.
114: Converter electronics warning – Phase current mismatch
The current in the converter electronics is out of phase. The unit should be returned for ser-
vice.