Adapter Installation
4. Insert the driver diskette, and type in the path of driver location: A :\Win_NT in
the above window, then click OK. (If installing the driver from a CD, make sure
to input the correct path. For example: D:\RR15xx\Windows\Driver\Win_NT)
5. Within the following window, select RocketRAID 154x/1640 Controller item, and
then click OK.
6. Confirm the following system prompts to finish the driver installation. When
installation is complete, restart the computer.
Installing the RocketRAID 1640 driver during Windows NT 4.0 installation
1. Press F6 key when the installation program prompts Setup is inspecting your
computer's hardware configuration.
2. NT setup will then proceed normally. Later, NT setup will display a new window
with an option to press the "S" key to specify other devices. Please press the "S"
key.
3. In the following window, select Other, then press the ENTER key to confirm.
4. Setup will then prompt you to insert the driver diskette. Insert the driver diskette,
and press ENTER to continue.
5. Next, select RocketRAID 154x/1640 Controller for WinNT4.0, and press
ENTER to continue.
6. The following window will list the devices that will be installed. The RocketRAID
154x/1640 Controller should be included.
(If other devices need to be installed, please install them at this time. If all of the
devices have been installed, please proceed to the next step.)
7. Press ENTER to confirm the devices to be installed and continue the installation
of Windows NT4.0.
Verify Installation
After the driver has been installed and the computer is restarted:
1. Click Start ---> Settings ---> Control Panel, and then double-click on SCSI
Adapters icon.
2. Within the SCSI Adapters window, see next page:
2-6
To Next Page
Loading...
Need help?
General
