Thermal Image Scope User Manual
20
Before You Start
Select a zeroing profile first.
Steps
1. In the main menu, rotate the wheel to select , and press the wheel to enter the setting
interface.
2. Select a zeroing No.
a) Rotate the wheel to select .
b) Press and rotate the wheel to select a zeroing No. to correct.
c) Press the wheel again to confirm.
4. Set distance to target.
a) Rotate the wheel to select .
b) Press the wheel to switch the digit.
c) Rotate the wheel to change the number, and press the wheel again to confirm.
5. Aim the target, trigger an activation, and start the zeroing.
a) Select , and press and rotate the wheel to enlarge the image until the target
positions is clear enough.
b) Rotate the wheel to select , press the wheel to freeze the image.
c) Select the or , and press the wheel to confirm. If you select , the reticle
moves left and right; if you select , the reticle moves up and down.
d) Rotate the wheel to move the big reticle to the required position.
e) Hold the wheel to save the settings according to the prompt.
Figure 4-2 Correct Reticle
To Next Page
Loading...
