Hikmicro PANTHER 2.0 Series - Chapter 2 Preparation; 2.1 Cable Connection; 2.2 Install Battery

Thermal Image Scope User Manual
4
Chapter 2 Preparation
2.1 Cable Connection
Connect the device and power adaptor with a type-C cable to power on the device. Alternatively,
connect the device and PC to export files.
Steps
1. Lift the cable interface cover.
2. Connect the device and power adapter with a Type-C cable to power on the device.
Alternatively, connect the device and PC to export files.
Figure 2-1 Cable Connection
2.2 Install Battery
2.2.1 Battery Instruction
● The battery type is 18650 with the protection board, and the battery size should be 19 mm × 70
mm. The rated voltage is 3.6 VDC, and the battery capacity is 3350 mAh (12.06 Wh).
● Charge the batteries for more than 4 hours before first use.
● Remove the battery if the device is not used for a long time.
● Please purchase the batteries recommended by the manufacturer if necessary.
2.2.2 Battery Installation
Insert the battery into the battery compartment.