Thermal Image Scope User Manual
32
60950-1 OR IEC 62368-1 standard.
Battery
● Improper use or replacement of the battery may result in explosion hazard. Replace with the
same or equivalent type only.
● The battery type is 18650 with the protection board, and the battery size should be 19 mm × 70
mm. The rated voltage and capacity are 3.6 VDC/3350 mAh (12.06 Wh). Dispose of used
batteries in conformance with the instructions provided by the battery manufacturer.
● Make sure the battery temperature is between 0 °C to 45 °C (32 °F to 113 °F) when charging.
● For long-term storage of the battery, make sure it is fully charged every half year to ensure the
battery quality. Otherwise, damage may occur.
● For the device without a supplied battery, use the battery provided by a qualified manufacturer.
Refer to the product specification for detailed battery requirements.
● Do not charge other battery types with the supplied charger. Confirm there is no flammable
material within 2 m of the charger during charging.
● DO NOT place the battery near heating or fire source. Avoid direct sunlight.
● DO NOT swallow the battery to avoid chemical burns.
● DO NOT place the battery in the reach of children.
● The battery cannot be charged with external power source directly.
● The device cannot be charged, please use the supplied charger to charge the battery.
● Please purchase the adapter by yourself. The using environment of the adapter should be
consistent with that of the device.
Maintenance
● If the product does not work properly, please contact your dealer or the nearest service center.
We shall not assume any responsibility for problems caused by unauthorized repair or
maintenance.
● Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the device may be impaired.
● Clean the lens with soft and dry cloth or wiping paper to avoid scratching it.
● It is recommended to reboot the device every 2 hours when using it to ensure the device
performance.
Using Environment
● Make sure the running environment meets the requirement of the device. The operating
temperature shall be -30°C to 55°C (-22°F to 131°F), and the operating humidity shall be 95% or
less.
● DO NOT expose the device to extremely hot, cold, dusty, corrosive, saline-alkali, or damp
environments.
● Avoid equipment installation on vibratory surface or places subject to shock (neglect may cause
equipment damage).
● DO NOT aim the lens at the sun or any other bright light.
To Next Page
Loading...
Need help?
General
