Digital Series Light Controller User Manual
2
Otherwise, there is a danger of electric shock.
●
Make sure that the device is installed in good condition, the wiring is firm, and the power
supply meets the requirements before powering on the device.
●
If the device emits smoke, odor or noise, please turn off the power and unplug the power
cord immediately, and contact the dealer or service center in time.
●
If the device does not work properly, please contact your dealer or the nearest service
center. Never attempt to disassemble the device yourself. We shall not assume any
responsibility for problems caused by unauthorized repair or maintenance.
●
Caution: If the device has battery, risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the instructions.
●
Please dispose of the device in strict accordance with the relevant national or regional
regulations and standards to avoid environmental pollution and property damage.
Note
●
Check whether the device's package is in good condition, whether there is damage,
intrusion, moisture, deformation, etc. before unpacking.
●
Check the surface of the device and accessories for damage, rust, bumps, etc. when
unpacking.
●
Check whether the quantity and information of the device and accessories are complete
after unpacking.
●
Store and transport the device according to the storage and transport conditions of the
device, and the storage temperature and humidity should meet the requirements.
●
It is strictly prohibited to transport the device in combination with items that may affect
or damage the device.
●
Please read the manual and safety instructions carefully before installing the device.
●
The device must not be exposed to water droplets or splashes, and it is strictly prohibited
to place anything containing liquids (such as vases) on the device.
●
Do not obstruct ventilation by covering items such as newspapers, tablecloths and
curtains. Do not place the device on a sofa, carpet, or other similar surfaces to avoid
blocking the heat dissipation holes.
●
Quality requirements for installation and maintenance personnel:
○
Qualification certificate or working experience in weak current system installation and
maintenance, and relevant working experience and qualifications. Besides, the
personnel must possess the following knowledge and operation skills.
○
The basic knowledge and operation skills of low voltage wiring and low voltage
electronic circuit connection.
○
The ability to comprehend the contents of this manual.
1.3 Electromagnetic Interference Prevention
●
Make sure that the shielding layer of cables is intact and 360° connected to the metal
connector when using shielded cables.
●
Do not route the device together with other equipment (especially servo motors, high-
power devices, etc.), and control the distance between cables to more than 10 cm. Make
sure to shield the cables if unavoidable.
To Next Page
