HikRobot SC7000 Series - Component and Indicator Descriptions; Lens Cap and Screw Holes; Light Source and Interfaces; Status Indicators

SC7000 Series Smart Camera User Manual
3
Table 2-1 Description
No.
Name
Description
1
Lens Cap
It is a transparent lens cap by default, and can be replaced with
other lens cap. Polarization lens cap is optional.
2
Screw Hole
It is used to fix the device to installation position. It is
recommended to use M4 screws.
3
Light Source
The device has 8 LED lamps to provide light. White lamp is default
one, and red, blue, or near infrared lamp is optional.
Note
The type II device does not have the internal light source.
4
Screw
For fixing the camera and the lens cap.
5
Gigabit Ethernet
Interface
It refers to gigabit Ethernet interface for transmitting data. The
interface is designed with screw threads to tighten connection
between the device and cable, and thus avoiding influence caused
by vibration.
6
12-Pin Interface
It provides power, input/output, and serial port signal. The
interface is designed with screw threads to tighten connection
between the device and cable, and thus avoiding influence caused
by vibration.
7
PWR Indicator
It is the power indicator. The indicator is solid blue when the device
operates normally.
8
LNK Indicator
It is network connection indicator. The indicator is solid green
when the network transmission is normal.
9
ACT Indicator
It is network transmission indicator. The indicator is flashing yellow
when the network transmission is normal. The indicator flashing
speed is related with data transmission speed.
10
U1/U2 Indicator
The device has 2 user-defined indicators, U1 and U2. They are used
to indicate whether some functions of the device are normal or
not.