HikRobot SC7000 Series - Trigger Mode Configuration; 8.2.2 Internal Trigger Mode; 8.2.3 External Trigger Mode; Software Trigger Mode

SC7000 Series Smart Camera User Manual
23
8.2.2 Enable Internal Trigger Mode
Go to Trigger Mode to select OFF as Trigger Mode.
Note
OFF refers to the internal trigger mode.
8.2.3 Enable External Trigger Mode
Go to Trigger Mode to select ON as Trigger Mode.
Note
ON refers to the external trigger mode.
Set and Execute Software Trigger Mode
Steps
1. Select ON as Trigger Mode.
2. Select SOFTWARE as Trigger Source.
3. Click Software Trigger to send trigger commands.
4. Enter Delay time according to actual demands.
Figure 8-6 Set and Execute Software Trigger Mode
Set and Execute Hardware Trigger Mode
Steps
1. Select ON as Trigger Mode.
2. Select Hardware as Trigger Source.
3. Select specific line as Trigger IO.