SC7000 Series Smart Camera User Manual
44
Figure 8-22 Set Operating Parameters
Result Display
In display area, you can set different judge methods of image detection result, including Blob
quantity, Blob area, centroid X, centroid Y, angle, center X, center Y, etc.
In Judge Method, enable Judge by Blob Quantity, Judge by Blob Area, Judge by Centroid X, Judge
by Centroid Y, Judge by Angle, Judge by Center X, Judge by Center Y, etc., and enter
corresponding range according to actual demands.
In Image Display, click to display or not display Blob and detection area. Click to edit OK
color, NG color, and transparency.
In Show Text, enable Display Text to set text's color, front size, transparency, position X, and
position Y.
Note
After applying Blob tool, you can view and select output results in the image display area. Refer to
section Operate Image for details.
8.4.10 Color Conversion
Note
This tool is available for color vison sensors only.
This tool is used to convert the color space in the specified area of the color image, and output the
To Next Page
Loading...
