HIKVISION 9 Series

2 Local Operaon
2.1
Acvate Indoor Staon
You can only congure and operate the indoor staon aer creang a password for
the device acvaon.
Steps
1.
Power on the device. It will enter the acvaon page automacally.
2.
Cr
eate a password and conrm it.
3.
T
ap OK to
acvate the indoor staon.
Note
We highly recommend you to create a strong password of your own choosing
(using a minimum of 8 char
acters, including at least three kinds of following
categories: upper case leers, lower case leers, numbers, and special
characters) in order to increase the security of your product. And we
recommend you change your password regularly, especially in the high security
system, changing the password monthly or weekly can beer protect your
product.
2.2 Conguraon
Sengs
Conguraon sengs is required before starng using the indoor staon. It is
necessary to set the indoor staon network, room No., linked devices, device me
display, and so on.
2.2.1 Set Indoor Staon Network Parameters
Network connecon is mandatory for the use of the indoor staon. Set the network
parameters aer acvang the indoor staon. Only when the IP address of the
indoor staon is in the same network segment as other devices, it can work properly
in the same system.
Steps
Note
The default IP address of the indoor staon is 192.0.0.64.
Video Intercom 9 Series Indoor Staon Conguraon Guide
2