HIKVISION 9 Series

Two ways are available for you to set IP address: DHCP, and set IP address manually.
1.
T
ap Sengs →
→ Conguraon
Sengs →
t
o enter the network sengs
page.
Note
Enter
acvate password as the admin password.
Figure 2-2 Network Sengs
2.
Enable DHCP, then the indoor staon can search and get an IP address
automacally.
Note
Skip the following steps if you have enabled DHCP.
3.
Se
t the Local IP, Subnet Mask and Gateway manually.
4.
Congure the DNS address according to your needs.
2.2.2 Set Linked Device IP
Linked network parameters refers to the network parameters of devices (like door
staon, doorphone, master
staon, center, etc.), to which the indoor staon is
linked. Linked devices for the indoor staon refers to door staon, center, master
staon, and doorphone.
Steps
Note
Here take door staon network sengs as example.
Video Intercom 9 Series Indoor Staon
Conguraon Guide
3