HIKVISION 9 Series

Local Network Conguraon
Steps
1.
Click Loc
al Network Conguraon to enter local network conguraon page.
Figure 3-18 Local Network Conguraon
2.
En
ter the local IP address, subnet mask, gateway address, and port No.
3.
Click Save to enable the sengs.
Note
•
The de
fault port No. is 8000.
•
Aer
eding the local network parameters of device, you should add the
devices to the device list again.
SIP Sengs
Steps
1.
Click SIP Sengs to enter the sengs page.
Video Intercom 9 Series Indoor Staon
Conguraon Guide
32