AX PRO User Manual
43
Data Used This Month
The used data will be accumulated and displayed in this text box.
4. Click Save.
Alarm Center
You can set the alarm center's parameters and all alarms will be sent to the configured alarm
center.
Steps
1. Click Communication Parameters ā Alarm Receiving Center to enter the Alarm Receiving
Center page.
2. Select the Alarm Receiver Center as 1 or 2 for configuration , and slide the slider to enable the
selected alarm receiver center.
Note
Only if the alarm receiver center 1 is enabled, you can set the alarm receiver center 2 as the
backup channel and edit the channel parameters.
3. Select the Protocol Type as ADM-CID, ISUP, SIA-DCS, *SIA-DCS, or *ADM-CID to set uploading
mode.
To Next Page
Loading...
