Network Camera User Manual
166
• Upload to FTP/Memory Card/NAS: Capture the image when an alarm is
triggered and upload the picture to a FTP server. And save the picture on the
local SD card or connected NAS.
9. Click the Save button to activate the settings.
Queue Management
Queue Management is a function to detect queuing-up people number and waiting
time of each person.
The camera also generates reports to compare the efficiency of different queuing-ups
and display the changing status of one queue.
To use the function, you should set up detection rules first. To see the statistics of
queue management, go to Application.
Note:
Queue management is only supported by certain camera models.
Rule Settings
The camera supports Regional People Queuing-Up, Waiting Time Detection and
Real-time Upload. Check checkbox to enable the desired function.
Regional People Queuing-Up: the function detects and calculates queuing-up
persons in defined regions, and trigger alarms when the alarm threshold condition
and the alarm trigger are both met.
Waiting Time Detection: the function detects and calculates the waiting time of
each person that enters the detection area, and trigger alarms when the alarm
threshold condition and the alarm trigger are both met.
Real-time Data Upload: the function detects the persons entering and exiting the
rule region and reports an alarm.
Steps:
1. Area Settings.
a) Add a region. Up to 3 regions are supported.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
