HIKVISION DS-2CD6425G1-20

3.
Select one Region. For the region  refer to Draw Area .
4.
Set 
 It stands for the percentage of the body part of an acceptable target that goes
across the  region.  = 100 - S1/ST × 100. S1 stands for the
target body part that goes across the  region. ST stands for the
complete target body. The higher the value of  is, the more easily the
alarm can be triggered.
Figure 6-6 Set Rule
5.
 You can set the parameters of  areas by  the above steps.
6.
For the arming schedule  refer to Set Arming Schedule . For the linkage method 
refer to Linkage Method  .
7.
Click Save.
6.2.7 Set Region  
It is used to detect objects  from a  virtual region. If it occurs, the device can take
linkage 
Steps
1.
Go to  → Event → Smart Event → Region  
2.
Check Enable.
3.
Select one Region. For the  region  refer to Draw Area .
4.
Set 
Network Camera User Manual
37