HIKVISION DS-2CD6425G1-20

9.5 Reboot
You can reboot the device via browser.
Go to  → System → Maintenance → Upgrade & Maintenance , and click Reboot.
9.6 Restore and Default
Restore and Default helps restore the device parameters to the default 
Steps
1.
Go to  → System → Maintenance → Upgrade & Maintenance .
2.
Click Restore or Default according to your needs.
Restore Reset device parameters, except user  IP parameters and video format
to the default 
Default Reset all the parameters to the factory default.
Note
Be careful when using this    to the factory default, all the
parameters are reset to the default 
9.7 Upgrade
Before You Start
You need to obtain the correct upgrade package.

DO NOT disconnect power during the process, and the device reboots   upgrade.
Steps
1.
Go to  → System → Maintenance → Upgrade & Maintenance .
2.
Choose one method to upgrade.
Firmware Locate the exact path of the upgrade 
Firmware Directory Locate the directory which the upgrade  belongs to.
3.
Click Browse to select the upgrade 
4.
Click Upgrade.
Network Camera User Manual
58