OPTION 1: Create the self-signed certificate
1) Select Create Self-signed Certificate.
2) Click Create to create the following dialog box.
Figure 2-14 Create Self-signed Certificate
3) Input the country, host name/IP, validity and other information.
4) Click OK to save the settings.
OPTION 2: Start the installation when signed certificate is available.
1) Select Signed certificate is available, Start the installation directly.
2) Click Browse to upload the available certificate.
3) Click Install button to install the certificate.
4) Click OK to save the settings.
OPTION 3: Create certificate request first and continue the installation.
1) Select Create certificate request first and continue the installation.
2) Click Create to create the certificate request, and fulfill the required information.
3) Download the certificate request and submit it to the trusted certificate authority for signature.
4) After receiving the signed valid certificate, import the certificate to the device.
5) Click OK to save the settings.
3. There will be the certificate information after you successfully create and install the certificate.
Figure 2-15 Installed Certificate Property
Note:
You can click configure the HTTPS port No. on your demand; refer to Section 2.2.1 Basic Settings -
Configuring Port Settings for details.
4. Check the Enable HTTPS checkbox and click Save.
Configuring QoS Settings
Purpose:
To Next Page
Loading...
Need help?
General
