DS-2TD2xxx-xxxx/xx Thermal and Optical Bi-Spectrum Network Camera User Manual
UM DS-2TD2xx-xxxx/xx Thermal 072020NA 31
Figure 5, Set Video Tampering Area
6. See Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for setting
linkage method.
7. Click Save.
6.3 Set Alarm Input
Alarm signal from an external device triggers corresponding actions of the current device.
Before You Start
Make sure the external alarm device is connected. See
Quick Start Guide
for cables connection.
1. Go to Configuration → Event → Basic Event → Alarm Input.
2. Check Enable Alarm Input Handling.
3. Select Alarm Input No. and Alarm Type from the drop-down list. Edit the Alarm Name.
4. See Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for setting
linkage method.
5. Click Copy to... to copy the settings to other alarm input channels.
6. Click Save.
To Next Page
Loading...
Need help?
General
