DS-2TD2xxx-xxxx/xx Thermal and Optical Bi-Spectrum Network Camera User Manual
UM DS-2TD2xx-xxxx/xx Thermal 072020NA 51
4. Check Enable Picture Overlay.
5. Drag the picture to adjust its position.
6. Click Save.
9.6 Set Manual DPC (Defective Pixel Correction)
If the amount of defective pixels in the image is comparatively small and accurate correction is needed,
you can correct these pixels manually.
1. Go to Configuration → Image → DPC.
2. Select the thermal channel.
3. Select manual mode.
4. Click the defective pixel on the image, then a cursor shows on live view.
5. Click Up, Down, Left, Right to adjust the cursor position to the defective pixel position.
6. Click , then click to correct the defective pixel.
If multiple defective pixels need to be corrected, click after locating a defective pixel.
Then, after locating other pixels, click to correct them simultaneously.
7. (Optional): Click to cancel defective pixel correction.
9.7 Set Picture-in-Picture
You can overlay the images of two channels and view the image of two channels at the same time.
1. Select a channel number.
2. Select the Picture-in-Picture mode.
• Normal Mode: Disable Picture-in-Picture mode.
• Overlay Mode: Enable Picture-in-Picture mode. You can overlay the image of another channel in the
current channel.
3. Click Save.
To Next Page
Loading...
Need help?
General
