DS-2TD2xxx-xxxx/xx Thermal and Optical Bi-Spectrum Network Camera User Manual
UM DS-2TD2xx-xxxx/xx Thermal 072020NA 33
Chapter 7 Arming Schedule and Alarm Linkage
Arming Schedule is a customized time period during which the device performs certain tasks. Alarm
linkage is the response to a detected incident or target during the scheduled time.
7.1 Set Arming Schedule
Set the valid time of the device tasks.
1. Click Arming Schedule.
2. Drag the time bar to draw the desired valid time.
Up to eight periods can be configured for one day.
3. Adjust the time period.
• Click on the selected time period, and enter the desired value. Click Save.
• Click on the selected time period. Drag both ends to adjust the time period.
• Click on the selected time period, and drag it on the time bar.
4. (Optional): Click Copy to... to copy the same settings to other days.
5. Click Save.
7.2 Linkage Method Settings
You can enable the linkage functions when an event or alarm occurs.
7.2.1 Trigger Alarm Output
If the device is connected to an alarm output device, and the alarm output no. has been configured, the
device sends alarm information to the connected alarm output device when an alarm is triggered.
1. Go to Configuration → Event → Basic Event → Alarm Output.
2. Set alarm output parameters.
• Automatic Alarm: For the information about the configuration, see Automatic Alarm.
• Manual Alarm: For the information about the configuration, see Manual Alarm.
3. Click Save.
Manual Alarm
You can trigger an alarm output manually.
1. Set the manual alarm parameters.
• Alarm Output No.: Select the alarm output no. according to the alarm interface connected to the
To Next Page
Loading...
Need help?
General
