HIKVISION DS-7108NI-K1/W/M - 4.3 Configure Motion Detection Recording

Network Video Recorder User Manual
47
Figure 4-10 Copy Schedule to Other Channels
4.3 Configure Motion Detection Recording
Follow the steps to set the motion detection. In the live view mode, once a motion detection
event takes place, the NVR can analyze it and take alarm response actions. Enabling motion
detection function can trigger certain channels to start recording, or trigger full screen monitoring,
audio warning, notify the surveillance center and so on. In this chapter, you can follow the steps to
schedule a record which triggered by the detected motion.
Steps
1. Go to Menu → Camera → Motion.
Figure 4-11 Motion Detection
2. Configure Motion Detection.
1) Choose camera you want to configure.
2) Check the checkbox after Enable Motion Detection.
3) Drag and draw the area for motion detection by mouse. If you want to set the motion
detection for all the area shot by the camera, click Full Screen. To clear the motion detection
area, click Clear.