User Manual of DS-7200-ST Series DVR
39
and make it record continuously all day.
Figure 8. Edit Schedule Settings
14. Click the OK button. This will take you back to the Schedule tab. To copy the schedule to a
different channel, select the channel or all under Copy To and click the Copy button.
15. Click Next button to access the Network Settings dialog box, shown in Figure 9.
Figure 9. Network Settings
16. To configure network settings, click the Enter button.
17. Enter the IP Address, Subnet Mask and Default Gateway settings.
18. Click OK button to return to the Setup Wizard.
19. If all the settings have been entered, click Done to finish the Setup Wizard.
20. If you have not initialized or formatted the HDD, the following prompt will pop up to remind you
to initialize the HDD.
You can click the Enter button to enter the HDD Management interface and select the HDD for
initialization, or you can click Cancel to exit the Setup Wizard.
Figure 10. Confirm HDD Initialization
To Next Page
Loading...
Need help?
General