Fig. 5.9 Display menu
When using IR remote control to operate DVR, you must use device ID to select
DVR. The default device ID of DVR is “255”. If there are more than one DVR in one
place, please define different device ID for each DVR. Otherwise, the IR remote
control will control all DVR with the same device ID at the same time.
In “Display” menu, move “Active Frame” to the device ID edit box, in the edit
status, you can use numeric keys to input new device ID. The device ID value is
ranged among 01-255.
After you finish the modification, press “Confirm” button to save and take effect
or press “Cancel” to abort modification.
To Next Page
Loading...
