Adjust preset description
In PTZ control mode, press【REC/SHOT】key, and press the preset number (three
numeric keys), DVR will adjust the corresponding preset number. Repeat pressing
【REC/SHOT】key, and press the preset number, DVR will adjust that preset number.
When you exit PTZ control mode, the camera will stay at the current position.
Note: The PTZ preset number is set already. Please refer to PTZ menu for preset setup. V2.1
firmware can support 128 preset at most.
Start/Stop auto in PTZ control mode
In PTZ control mode, press【PLAY/AUTO】key to start PTZ auto function. Press
【PLAY/AUTO】key again to stop.
When PTZ is in auto mode, if you exit PTZ control mode, PTZ will continue
auto function unless you enter into PTZ control mode again, and press
【PLAY/AUTO】key to stop.
Exit PTZ control mode
Press【ESC】or【ENTER】to exit and return preview mode.
24
To Next Page
Loading...
