5.3
Unit
isplay” menu, shown as fig 5.8:
Unit Name and Device ID
name
In the “D
Fig 5.8 Display menu
There is an item named “Unit Name”. The default unit name is “Embedded Net
DVR”. Move “Active Frame” to unit name edit box, press【EDIT】key to enter into
edit status, you can modify the unit name. About how to input characters, please refer
to chapter 3.4. Press【ENTER】key to finish modification. Select “Confirm” button
and press【ENTER】, you can save the new unit name and make it into effect. Press
“Cancel” button or【ESC】key to abort modification.
Device ID:
When you use IR controller to operate DVR, you must use device ID to select
DVR. The default device ID of DVR is “88”. If there are more than one DVR in one
place, please define different device ID for each DVR. Otherwise, the IR controller
will control all DVR with the same device ID at the same time.
In “Display” menu, move “Active Frame” to the device ID edit box, in the edit
status, you can use numeric keys to input new device ID. The device ID value is
ranged among 01-255.
After you finish the modification, press “Confirm” button to save and take effect
40
To Next Page
Loading...
