support preset function before you setup preset.
Sequence setup: Each sequence is made up of several cruise points. Each cruise point
includes one preset number, dwell time and dwell speed. Please make sure the PTZ you are using
can support sequence function before you start to setup. You can save 16 sequences.
Cruise setup: Cruise is remembering the track of PTZ movement. Please make sure the PTZ
you are using can support cruise function.
Preset setup
In “PTZ” menu, move “Active Frame” to “Setup” button on the right side of “Preset” item,
press【ENTER】, you can enter into “Preset” setup menu: Shown as fig 5.30
Fig 5.30 PTZ preset setup
Add preset number: You can input preset number (among 1-128) in the edit box. Then press
“Adjust” button to enter into PTZ control interface. In PTZ control interface, you can use direction
keys to adjust PTZ position, and use【IRIS+】【IRIS-】【FOCUS+】【FOCUS-】【ZOOM+】【ZOOM-】
keys
set numbers, press “Return” button to return “PTZ” menu. In “PTZ”
men
to adjust iris, focus and zoom. After you finish adjusting, press【ENTER】, then press “Save”
button to save the preset number. You can repeat this step to setup other preset numbers.
After you setup all pre
u, press “Confirm” button to save all parameters.
Delete preset number: In “Preset” setup menu, input one preset number, press “Delete”
72
To Next Page
Loading...
Need help?
General