HIKVISION DS-7608NI-SE/8P - Setting up the Network

www.hikvision.com/en/us
Networking a NVR requires 3 steps:
1. Assign an IP address, Default Gateway, Subnet Mask, and a DNS server (Please note: DNS,
not DDNS) to the NVR
2. Forward the appropriate ports on the router (Port Forwarding).
3. Register DDNS (DDNS registration is required only if the public IP address is Dynamic).
To assigning an IP ADDRESS, go to “MENU”>”SYSTEM CONFIGURATION”>”NETWORK”
5. SETTING UP THE NETWORK
SETTING UP NETWORK ACCESS
General
IP CONFIGURATION
 Please note that the NVR have a default IP Address set to 192.0.0.64
Enable
DHCP
With DHCP
enabled, the
router will
assign an IP
address to
the NVR
Select NIC
Type