HIKVISION DS-8600 - Configuring General Settings

User Manual of DS-9600/8600/7700/7600 Series NVR
136
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration>Network
2. Select the General tab.
DS-9600NI-ST/RT/XT and DS-8600NI-ST
DS-7700/7600NI-ST
DS-7700/7600NI-SP
Figure 9. 1 Network Settings Interface
Note: Dual-NIC configuration is only applicable for DS-9600NI-ST/RT/XT and DS-8600NI-ST series
NVR.
3. In the General Settings interface, you can configure the following settings: Working Mode, NIC Type, IPv4
Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP address