HIKVISION DS-9600NXI-I8/S Series - IR Remote Control Operations; Pair (Enable) the IR Remote to a Specific NVR (Optional)

Network Video Recorder User Manual
9
1.3 IR Remote Control Operations
The NVR may also be controlled with the included IR remote control.
Note
Batteries (2×AAA) must be installed before operation.
The IR Remote is set at the factory to control the NVR (using default Device ID# 255) without any
additional steps. Device ID# 255 is the default universal device identification number shared by the
NVRs. You may also pair an IR Remote to a specific NVR by changing the Device ID#, as follows:
1.3.1 Pair (Enable) the IR Remote to a Specific NVR (optional)
You can pair an IR Remote to a NVR by creating a user-defined Device ID#. This feature is useful
when using multiple IR Remotes and NVRs.
Steps
1. On the NVR:
1) Go to General → More Settings.
1) Type a number (255 digits maximum) into the Device No. field.
2. On the IR Remote:
1) Press DEV.
1) Use the Number buttons to enter the Device ID# that was entered into the NVR.
2) Press Enter button to accept the new Device ID#.