Video Wall Controller • Quick Start Guide
11
Chapter 2 Installation
Safety Precautions
As a high-precision, system-level electronic product, the device should be installed and maintained
by professionals.
In order to avoid personal and property injury, please read the safety precautions in this section
carefully before installation. The following safety recommendations do not cover all possible
dangerous situations.
Electricity Safety
During the installation, wiring, disassembly, and maintenance of the device, please disconnect
the power supply and do not operate with electricity (except for the operation of the hot
plug).
In the installation and use of the device, make sure to follow the local electrical safety
regulations.
In case of abnormal phenomena such as smoke or odor occur during the use of the device,
please cut off the power immediately, unplug the power cord from the socket, and contact
the after-sales service center in time.
Anti-Static Measures
The equipment is a precision electronic device. In order to avoid static electricity from damaging
the components, in addition to anti-static measures in the equipment room, you also need to pay
attention to the following measures:
During the installation process (especially when installing the main control board and service
board), you must wear anti-static gloves or anti-static wrists.
When holding the main control board or the service board, try to avoid touching the
components or printed circuits.
Grounding Requirements
In order to ensure personal safety and device safety, the device must be grounded.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
