HIKVISION DS-K1T642MFW User Manual

-
If disable DHCP, you should enter the IP address, the subnet mask, and the gateway manually.
6.
Tap OK to save the sengs and go back to the Wi-Fi tab.
7.
Tap to save the network parameters.
7.2.3 Set RS-485 Parameters
The face recognion terminal can connect external access controller, secure door control unit or
card reader via the RS-485 terminal.
Steps
1.
Tap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2.
On the Communicaon Sengs page, tap RS-485 to enter the RS-485 tab.
Figure 7-6 Set RS-485 Parameters
3.
Select an peripheral type according to your actual needs.
Note
If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
4.
Tap the back icon at the upper le corner and you should reboot the device if you change the
parameters.
Face Recognion Terminal User Manual
36

HIKVISION DS-K1T642MFW Specifications

General

Type	-
Log capacity	150000
Product color	Black
Cards capacity	10000 cards
RFID frequency	13.56 MHz
Languages support	ARA, ENG, ESP, THA, POR, RUS, VIE
Recommended usage	Indoor
Fingerprint reader	Yes
Authentication type	Access chip/card, Biometric, Face recognition
Access chip/card reader type	Contactless
RS-485 ports	1
Cabling technology	10/100/1000
Supported network protocols	ISUP 5.0, ISAPI, NetSDK, HikCentral Pro OpenAPI, Hik-ProConnect OpenAPI
Display diagonal	4.3 \
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	0 - 90 %
Total megapixels	2 MP
Front camera type	Dual camera
Viewing angle, vertical	75.5 °
Viewing angle, horizontal	41.5 °

Weight and Dimensions

Depth	20 mm
Width	118 mm