EasyManuals Logo

HIKVISION DS-K1T642MFW User Manual

HIKVISION DS-K1T642MFW
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
All parameters, except for the communicaon sengs, remotely imported user informaon, will
be restored to the default sengs. The system will reboot to take eect.
Restore to Factory Sengs
All parameters will be restored to the factory sengs. The system will reboot to take eect.
Reboot
Reboot the device.
7.11 Video Intercom
Aer
adding the device to the client soware, you can call the device from the client soware, call
the main staon from the device, call the client soware from the device, or call the indoor staon
from the device.
7.11.1 Call Client
Soware from Device
Steps
1.
Get the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2.
Run the client
soware and the control panel of the soware pops up.
3.
Click Device Management to enter the Device Management interface.
4.
Add the device to the client
soware.
Note
For details about adding device, see Add Device.
5.
Call the client soware.
1) Tap on the device inial page.
2) Enter 0 in the pop-up window.
3) Tap
to call the client soware.
6.
Tap Answer on the pop-up page of the client soware and you can start two-way audio between
the device and the client soware.
Note
If the device is added to mulple client sowares and when the device is calling the client
soware, only the rst client soware added the device will pop up the call receiving window.
7.11.2 Call Center from Device
Steps
1.
Get the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
Face Recognion Terminal User Manual
60

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-K1T642MFW and is the answer not in the manual?

HIKVISION DS-K1T642MFW Specifications

General IconGeneral
Type-
Log capacity150000
Product colorBlack
Cards capacity10000 cards
RFID frequency13.56 MHz
Languages supportARA, ENG, ESP, THA, POR, RUS, VIE
Recommended usageIndoor
Fingerprint readerYes
Authentication typeAccess chip/card, Biometric, Face recognition
Access chip/card reader typeContactless
RS-485 ports1
Cabling technology10/100/1000
Supported network protocolsISUP 5.0, ISAPI, NetSDK, HikCentral Pro OpenAPI, Hik-ProConnect OpenAPI
Display diagonal4.3 \
Operating temperature (T-T)-10 - 55 °C
Operating relative humidity (H-H)0 - 90 %
Total megapixels2 MP
Front camera typeDual camera
Viewing angle, vertical75.5 °
Viewing angle, horizontal41.5 °
Weight and Dimensions IconWeight and Dimensions
Depth20 mm
Width118 mm

Related product manuals