EasyManuals Logo

HIKVISION DS-K1T642MFW User Manual

HIKVISION DS-K1T642MFW
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
2.
Run the client soware and the control panel of the soware pops up.
3.
Click Device Management to enter the Device Management interface.
4.
Add the main staon and the device to the client soware.
Note
For details about adding device, see Add Device.
5.
Set the main
staon's IP address and SIP address in the remote conguraon page.
Note
For details about the operaon, see the user manual of the main staon.
6.
Call the center.
-
If you have congured to call center in the Basic Sengs , you can tap to call the center.
-
If you have not
congured to call center in the Basic Sengs , you should tap to call
the center
7.
Answers the call via the main
staon and starts two-way audio.
Note
The device will call the main staon in priority.
7.11.3 Call Device from Client Soware
Steps
1.
Get the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2.
Run the client soware and the control panel of the soware pops up.
3.
Click Device Management to enter the Device Management page.
4.
Add the device to the client
soware.
Note
For details about adding device, see Add Device.
5.
Enter the Live View page and double-click the added device to start live view.
Note
For details about operaons in the Live View page, see Live View in the user manual of the client
soware.
6.
Right click the live view image to open the right-click menu.
7.
Click Start Two-Way Audio to start two-way audio between the device and the client soware.
Face Recognion Terminal User Manual
61

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-K1T642MFW and is the answer not in the manual?

HIKVISION DS-K1T642MFW Specifications

General IconGeneral
Type-
Log capacity150000
Product colorBlack
Cards capacity10000 cards
RFID frequency13.56 MHz
Languages supportARA, ENG, ESP, THA, POR, RUS, VIE
Recommended usageIndoor
Fingerprint readerYes
Authentication typeAccess chip/card, Biometric, Face recognition
Access chip/card reader typeContactless
RS-485 ports1
Cabling technology10/100/1000
Supported network protocolsISUP 5.0, ISAPI, NetSDK, HikCentral Pro OpenAPI, Hik-ProConnect OpenAPI
Display diagonal4.3 \
Operating temperature (T-T)-10 - 55 °C
Operating relative humidity (H-H)0 - 90 %
Total megapixels2 MP
Front camera typeDual camera
Viewing angle, vertical75.5 °
Viewing angle, horizontal41.5 °
Weight and Dimensions IconWeight and Dimensions
Depth20 mm
Width118 mm

Related product manuals