HIKVISION DS-K1T805EBFWX User Manual

Chapter 5 Acvaon
You should acvate the device before the rst login. Aer powering on the device, the system will
switch to Device
Acvaon page.
Acvaon via the device, SADP tool and the client soware are supported.
The default values of the device are as follows:
●
The default IP address: 192.0.0.64
●
The default port No.: 80
●
The default user name: admin
5.1
Acvate via Mobile Web
You can acvate the device via mobile web.
Steps
Note
●
Aer powering on the device for the rst me, the hotspot funcon is enabled by default.
●
Only the device with Wi-Fi funcon supports acvaon via AP mode.
1.
Connect to the device hotspot with your mobile phone by entering the hotspot password. The
acvaon page will pop up.
Note
●
If automac pop-up failed. Enter the device default IP or enter www.acsvis.com in the browser
to enter the acvaon page.
●
For inacve devices, the device hotspot name is AP_Serial Number, and the hotspot password
is the device serial number.
●
The device is in the AP mode by default. The AP mode will be disabled aer 30 min. Hold key 5
for 10 s to enter the AP mode again.
●
Aer device acvaon, the hotspot password will be changed to the device acvaon
password.
2.
Create a new password (admin password) and conrm the password.
Note
Characters containing admin and nimda are not supported to be set as acvaon password.
Cauon
STRONG PASSWORD RECOMMENDED-We highly recommend you create a strong password of
your own choosing (using a minimum of 8 characters, including upper case leers, lower case
Access Control Terminal User Manual
15

HIKVISION DS-K1T805EBFWX Specifications

General

Brand	HIKVISION
Model	DS-K1T805EBFWX
Category	Touch terminals
Language	English