HIKVISION DS-K1T805EBFWX - Fingerprint Parameters Settings

Note
If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
Baud Rate
The baud rate when the devices are communicang via the RS-485 protocol.
Data Bit
The data bit when the devices are communicang via the RS-485 protocol.
Stop Bit
The stop bit when the devices are communicang via the RS-485 protocol.
Parity/Flow Ctrl/Communicaon Mode
Enabled by default.
Output Type
Set the output type according to your actual needs.
9.4.9 Fingerprint Parameters
Sengs
Set ngerprint security level.
Tap
→ Smart .
Figure 9-7 Fingerprint Security Level
Note
The funcons vary according to dierent models. Refers to the actual device for details.
Select the security level according to actual needs. Tap Save to save the sengs.
Access Control Terminal User Manual
57