HIKVISION DS-K1T805EBFWX - Page 42

1) Set the IP address, subnet mask, and default gateway. Or enable DHCP and the system will
allocate the IP address, subnet mask, and default gateway automacally.
6.
Click Save.
Device Hotspot
Set the device hotspot.
Click Conguraon → Network → Network Sengs → Device Hotspot .
Click Enable Device Hotspot to enable the funcon and view the device hotspot name.
Note
By default, the hotspot name is the AP_Device Serial No.
Click Save.
Bluetooth
Sengs
You can enable bluetooth funcon.
Click Conguraon → Network → Network Sengs → Bluetooth .
Open
Enable Open to enable the bluetooth funcon.
Device Name
You can edit the device name connected to the bluetooth.
Connecon Status
You can view the connecon status.
Open Door via Bluetooth
Aer enabling this funcon, you can open doors via or HikCentral Access Control (HCAC).
Note
You should add devices to the HCAC before opening door via bluetooth. Via HCAC, you can also
realize the auto door open funcon. for details, scan the QR code to view HCAC's user manual.
Access Control Terminal User Manual
29