HIKVISION DS-K1T805EBFWX - Page 68

You can set the exit buon as Remain Open or Remain Closed according to your actual needs.
By default, it is Remain Open.
Door Remain Open Duraon with First Person (min)
Set the door open duraon when rst person is in. Aer the rst person is authorized, it allows
mulple persons access the door or other authencaon acons.
Door Open Timeout Alarm
An alarm will be triggered if the door has not been closed within the
congured me duraon.
Door Contact
You can set the door contact as Remain Open or Remain Closed according to your actual needs.
By default, it is Remain Closed.
Extended Open Duraon
The door contact can be enabled with appropriate delay aer person with extended access
needs swipes her/his card.
Duress Code
The door can open by inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Super Password
The
specic person can open the door by inpung the super password.
Unlock Password
The specic person can open the door by inpung the unlock password.
Note
The duress code and the super code should be dierent. And the digit ranges from 4 to 8.
Terminal Parameters
You can set terminal parameters for accessing.
Tap
→ Access Control → Terminal Parameters .
You can set Working Mode as Access Control Mode. The access control mode is the device normal
mode. You should
authencate your credenal for accessing.
Tap Save to save the sengs aer the conguraon.
Set Card Security
Tap
→ Access Control → Card Security to enter the conguraon page.
Set the parameters and tap Save.
Enable NFC Card
Access Control Terminal User Manual
55