HIKVISION DS-K27 Series User Manual

Card Reader Type/Card Reader Descripon
View the card reader's type and descripon.
Enable Authencaon Device
Enable the authencaon funcon.
Authencaon
Interval
You can set the authencaon interval of the same person when authencang. The same
person can only authencate once in the congured interval. A second authencaon will be
failed.
Alarm of Max. Failed
Aempts
Enable to report alarm when the card reading aempts reach the set value.
Max. Authencaon Failed Aempts
Enable to report alarm when the card reading aempts reach the set value.
Communicaon with Controller Every
When the access control device cannot connect with the card reader for longer than the set
me, the card reader will turn oine automacally.
Max. Interval When Entering Password
When you entering the password on the card reader, if the interval between pressing two
digits is longer than the set value, the digits you pressed before will be cleared automacally.
OK LED Polarity/Error LED Polarity/Buzzer Polarity
Set OK LED Polarity/Error LED Polarity/Buzzer Polarity of the access control device according
to the card reader parameters. Generally, adopts the default sengs.
Tampering Detecon
Enable the an-tamper detecon for the card reader.
QR Code
Enable the funcon and the card reader can recognize the QR code for authencaon.
Note
The funcon should be supported by the card reader.
Bluetooth Parameter Conguraon
Enable Bluetooth
Enable the bluetooth funcon and the you can use the bluetooth funcon (e.g. opening
door) on the card reader.
Device Name/Transming Power
Edit the card reader's name and its transming power.
Open Door via Bluetooth
DS-K27XX Series Access Controller User Manual
35

HIKVISION DS-K27 Series Specifications

General

Brand	HIKVISION
Model	DS-K27 Series
Category	IP Access Controllers
Language	English