HIKVISION DS-K27 Series User Manual

Set the access point's acon.
Click to delete single card reader. Check the card readers and click Delete to delete in
batch.
Linked Alarm Output
If the Linkage Type in the Event Source is Card Linkage, when enable Linked Alarm Output,
you can set Triggering Times Conguraon, Triggering Times (Enable), and Triggering Times
(Disable).
If set Triggering Times (Enable) as 3, and Triggering Times (Disable) as 3, you can present the
card that
congured in the Event Source for 3 me to stop alarm when the following alarm
output in the list is in open status. If the alarm output is in the disabled status, you can
present the card for 3 mes to trigger alarm.
Set the alarm output. Click Add and check the alarm outputs in the list and click Save.
Click
to set the alarm duraon. Click Save.
Note
Aer the conguraon is completed, the conguraon of the same output linked to other
acons will also be changed.
Connuous Alarm
The alarm output device will connuously in the alarm status.
Custom Alarm Duraon
You should set the custom duraon. The alarm output device will be in the alarm status for
the congured me duraon.
Note
Range: from 0 to 5999s.
5.
Click Save.
Alarm
Sengs
Set the device's alarm output parameters.
Click System and Maintenance → System
Conguraon → Event → Alarm Sengs → Alarm
Output .
Select an access point from the list on the
le. Select a alarm output device No. Create a name for
the alarm output device and set the alarm duraon. Click Save.
Connuous Alarm
The alarm output device will connuously in the alarm status.
Custom Alarm Duraon
DS-K27XX Series Access Controller User Manual
61

HIKVISION DS-K27 Series Specifications

General

Brand	HIKVISION
Model	DS-K27 Series
Category	IP Access Controllers
Language	English