HIKVISION DS-K27 Series

In order to prevent the mobile phone from geng the data of the access control, you can
enable NFC card to increase the security level of the data.
Enable M1 Card
Enable M1 card and authencang by presenng M1 card is available.
M1 Card Encrypon
Sector
M1 card
encrypon can improve the security level of authencaon.
Enable the funcon and set the encrypon sector. By default, Sector 13 is encrypted. It is
recommended to encrypt sector 13.
Enable EM Card
Enable EM card and authencang by presenng EM card is available.
Note
If the peripheral card reader supports presenng EM card, the funcon is also supported to
enable/disable the EM card funcon.
Enable DESFire Card
The device can read the data from DESFire card when enabling the DESFire card funcon.
DESFire Card Read Content
The device can read the DESFire card content.
Enable FeliCa Card
The device can read the data from FeliCa card when enabling the FeliCa card funcon.
Set Card No.
Authencaon Parameters
Set the card reading content when authencate via card on the device.
Go to System and Maintenance → System Conguraon → Card Sengs → Card No. Auth.
Sengs .
Select a card authencaon mode and set the reversed card No. and click Save.
Full Card No.
All card No. will be read.
3 bytes
The device will read card via Wiegand 26 protocol (read 3 bytes).
4 bytes
The device will read card via Wiegand 34 protocol (read 4 bytes).
Enable Reversed Card No.
The read card No. will be in reverse sequence
aer enabling the funcon.
DS-K27XX Series Access Controller User Manual
65