HIKVISION DS-K3G411 Series - Page 27

Interface Name Terminal Name Descripon Remark
Terminal Accessing
(Default)
is for entering, and
4 is for exing.
• If the visitor card is
congured, you
should wire two
card readers for the
exing side. One's
DIP address is 4,
and the other is 3.
Card Reader 3 can
be applied together
with the card
receiver. The normal
user can
authencate on
Card Reader 4 and
the visitor can
authencate on
Card Reader 3.
• You can switch the
communicaon
mode between
RS-485 and RS-232.
For details about
the DIP switch
descripon, see
Main Control Board
DIP Switch
Descripon
GND
Grounding
RS-485C/RS-232C 485C+ RS-232_RX Terminal of
Fingerprint Recorder
Accessing (Default)
Note
• The DIP of RS-485
card ID is set as 1
and 4 by default. 1
is for entering, and
4 is for exing.
• If the visitor card is
congured, you
should wire two
card readers for the
exing side. One's
485C- RS-232_TX Terminal of
Fingerprint Recorder
Accessing (Default)
GND Grounding
DS-K3G411 Series Tripod Turnsle Quick Start Guide
16