HIKVISION DS-K3G411 Series - Page 28

Interface Name Terminal Name Descripon Remark
DIP address is 4,
and the other is 3.
Card Reader 3 can
be applied together
with the card
receiver. The normal
user can
authencate on
Card Reader 4 and
the visitor can
authencate on
Card Reader 3.
• You can switch the
communicaon
mode between
RS-485 and RS-232.
For details about
the DIP switch
descripon, see
Main Control Board
DIP Switch
Descripon
RS-232H
232H+ RS-232_RX Terminal of
QR Code Scanner
Accessing (Default)
Note
The terminal is for
RS-232
communicaon only.
You cannot switch its
communicaon mode.
232H- RS-232_TX Terminal of
QR Code Scanner
Accessing (Default)
GND Grounding
5 V Power Output 5 V 5 V Power Output /
GND Grounding
Wiegand Card Reader
1
OK1 Indicator of Card
Reader Control Output
(Invalid Card Output)
Note
The Wiegand card
reader 1 refers to the
card reader (entering).
ERR1 Indicator of Card
Reader Control Output
(Valid Card Output)
DS-K3G411 Series Tripod Turnsle Quick Start Guide
17