HIKVISION DS-KH6320-WTE2 User Manual

1) Enable Enable Standard SIP.
2) Tap VOIP Account Sengs and congure the account informaon, including
the user name, the phone number, the registered user name, the password,
the domain, the port No., and the expiraon date.
Note
Up to 32 characters are allowed in the user name.
2.3.5 Add Camera
Steps
1.
Tap
Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap to enter the device management page.
3.
Tap + to pop up the dialog box.
4.
Select HIK Protocol and you can add the camera depended on the HIK protocol.
5.
Enter the device name and IP address.
6.
Enter the device user name and the password of the camera.
7.
Exit the page to save the sengs.
2.3.6 Zone and Alarm Sengs
Zone Sengs
You can set the zone type, alarm type and delay me and other parameters of 8
zones.
Before You Start
Tap
Sengs → → Shortcut Sengs , and enable Alarm.
Steps
Note
Arming status page and zone sengs page are hidden by default. You should enable
alarm funcon rst.
1.
Tap Sengs → → Zone Sengs to enter the zone sengs page.
Video Intercom Indoor
Staon Conguraon Guide
10

HIKVISION DS-KH6320-WTE2 Specifications

General

Color	Yes
Speakerphone	-
Connectivity technology	Wireless
Voice codecs	G.711u
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	32 GB
Display diagonal	7 \
Touchscreen type	Capacitive
Display resolution	1024 x 600 pixels
Display technology	LCD/TFT
Product color	Black, Grey
Operating system installed	Linux
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Supported network protocols	TCP/IP, SIP, RTSP
Outdoor unit included	No
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	10 - 90 %
Power consumption (typical)	6 W

Weight and Dimensions

Depth	15.1 mm
Width	200 mm
Height	140 mm