HIKVISION DS-KH6320-WTE2 User Manual

3.
Select Device Type as Indoor Extension.
4.
Enter the required informaon.
Serial No.
Enter the device's serial No.. The serial No. is on the rear panel of the device
(A xed-length number with 9 digits).
IP Address
Enter the device's IP address.
Gateway
Enter the device's gateway.
Subnet Mask
Enter the device's subnet mask.
Password
Enter the device password, ranging from 8 to 16 characters in length.
No.
Enter the device No., ranging from 1 to 5.
5.
Click Save to enable the
sengs.
6.
Set SIP informaon.
Click
Congure Congure serial No., IP address, gateway, subnet mask,
password and No. of the device.
Click Delete Delete the SIP Number.
Click Clear Clear all SIP numbers.
Click Refresh Refresh SIP Informaon.
3.4.3 Network
Local Network Conguraon
Steps
1.
Click Local Network Conguraon to enter the conguring the local network
parameters page.
Video Intercom Indoor
Staon Conguraon Guide
39

HIKVISION DS-KH6320-WTE2 Specifications

General

Color	Yes
Speakerphone	-
Connectivity technology	Wireless
Voice codecs	G.711u
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	32 GB
Display diagonal	7 \
Touchscreen type	Capacitive
Display resolution	1024 x 600 pixels
Display technology	LCD/TFT
Product color	Black, Grey
Operating system installed	Linux
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Supported network protocols	TCP/IP, SIP, RTSP
Outdoor unit included	No
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	10 - 90 %
Power consumption (typical)	6 W

Weight and Dimensions

Depth	15.1 mm
Width	200 mm
Height	140 mm