HIKVISION DS-KH9310-WTE1 Configuration Guide

For indoor staon, you can change the admin password, arm/disarm password,
unlock pass
word and duress code.
For indoor extension, only admin password and arm/disarm password need to be
congured.
Zone Alarm
Steps
1.
Click Zone Alarm to enter the zone
sengs page.
Figure 3-10 Zone Alarm
2.
Select a zone type from the drop-down list menu.
3.
Select an alarm mode from the drop-down list menu.
4.
Set the zone status: NO or NC.
5.
Set the entering delay, and exing delay.
6.
Select trig
gers.
7.
Click Save to enable zone sengs.
Note
•
7 z
one types are supported: Emergency Switch, Door
Magnec Switch,
Smoke Detector, Acve IR Detector, Passive IR Detector, Combusble Gas
Detector, and DoorBell Switch.
•
3 types of alarm mode are supported: Instant Alarm, 24H Alarm, and Delay
Alarm.
•
When the zone type is set to be Instant Alarm, only under arming mode, the
indoor staon will receive alarm message when the detector is triggered.
Video Intercom 9 Series Indoor Staon Conguraon Guide
26

HIKVISION DS-KH9310-WTE1 Specifications

General

Brand	HIKVISION
Model	DS-KH9310-WTE1
Category	Intercom System
Language	English