HIKVISION DS-KIS603-P Configuration Guide

Figure 2-11 Zone Alarm
2.
Select Zone No.
3.
Select Zone Type.
4.
Select Alarm Type.
5.
Set the NO/NC status.
6.
Set Entering Delay and Exing Delay.
7.
Select triggers.
8.
Click Save to enable zone sengs.
Note
•
7 zone types are supported: Emergency Switch, Door Magnec Switch,
Smoke Detector, Acve IR Detector, Passive IR Detector, Combusble Gas
Detector, and DoorBell Switch.
•
3 types of alarm mode are supported: Instant Alarm, 24H Alarm, and Delay
Alarm.
•
When the zone type is set to be Instant Alarm, only under arming mode, the
indoor staon will receive alarm message when the detector is triggered.
Under disarming mode, it will not receive alarm message when the detector
is triggered.
•
When the zone type is set to be 24H Alarm, the indoor
staon will receive
alarm message when the detector is triggered no maer it is under arming
mode or disarming mode.
Network Indoor
Staon Conguraon Guide
28

HIKVISION DS-KIS603-P Specifications

General

Model	DS-KIS603-P
Category	Intercom System
Resolution	1024 x 600
Camera	2 MP HD Camera
Audio Input	Built-in Omnidirectional Microphone
Audio Output	Built-in Loudspeaker
Operating Temperature	-10°C to 55°C (14°F to 131°F)
Supported Protocols	TCP/IP, SIP, RTSP
Display	7-inch TFT LCD
Network Protocol	TCP/IP
Power Supply	12 VDC
Installation	Surface Mount
IR Supplement	IR Supplement
Protection Level	IP65
Power Consumption	<10 W
Humidity	10% - 90% (non-condensing)
Communication Interface	Ethernet