Panic Alarm Stationļ User Manual
27
Network Center Settings
Purpose:
In this section, you can configure the parameters (such as server type, IP address, port NO.,and so on) of the network center.
Steps:
1. Click Remote Configuration > Network > Network Center Configuration to enter the network center configuration interface.
2. Click and select a network center. Two centers are selectable.
3. Click Enable Upload Center.
4. Click the dropdown menu to select a sever type. Two sever types are available: IP4/IP6 and domain.
5. Enter the IP address which is used to communicate with the network alarm receiving center.
6. Enter the port NO. for communicating with the alarm receiving center.
7. Click the dropdown menu to select the protocol type.
8. Enter the username which is applying for displaying in the alarm receiving center.
The length of the username should be 6 characters.
Only numeric (0~9), and letter (A~F&a~f) are valid for this username.
Call Center Settings
Purpose:
You can configure the parameters (such as report uploading time period, center name, phone number and so on) for each call
center in this section.
Steps:
1. Click Remote Configuration > Network > Call Center Configuration to enter the call center configuration interface.
To Next Page
Loading...
Need help?
General
