Panic Alarm Station User Manual
18
Chapter 3 Remote Settings
In the client software, go to Device Management, click and select the device in the device list, and
click to enter the Remote Configuration page.
Note
● The device should be activated the first time it is used to log in and use properly. See Activation
to activate the device.
● You need to add the device to the client software before configure it. See Add Device via Client
Software.
● Get the client software from the technical support, and install the software according to the
prompts.
Device Management
Before You Start
Activate the device and ensure that the device is on the same subnet as the PC.
Client Software Main Page
In the client software, go to Device Management → Device on the Maintenance and
Management list. You can add devices to client software by several methods on the device
To Next Page
Loading...
Need help?
General
