HIKVISION KH6 Series

Figure 3-12 Device Management
Set the parameters of the linked door
staon. Tap to set parameters of the door staon.
3.
Select a device to link. Edit following parameters.
Name
You can edit the name of the device.
Language
Select a language from the drop-down list for the device.
Network
Enable Auto Get IP Address and the system will assign network parameters
automacally, or
you can edit network parameters manually.
Door Lock Parameters
Aer wire the lock with the door staon, you can set name and door opening duraon
according to your needs.
Volume Sengs
Set microphone volume and output volume.
Call Number Sengs
The call No. should be the same as the indoor staon's room No. If press the call buon of
the door
staon, you can call the indoor staon directly.
Network Indoor Staon User Manual
17