HIKVISION KH6 Series User Manual

4.
Enter the required informaon.
Serial No.
Enter the device's serial No.. The serial No. is on the rear panel of the device (A xed-length
number with 9 digits).
IP Address
Enter the device's IP address.
Gateway
Enter the device's gateway.
Subnet Mask
Enter the device's subnet mask.
Password
Enter the device password, ranging from 8 to 16 characters in length.
No.
Enter the device No., ranging from 1 to 5.
5.
Click Save to enable the
sengs.
6.
Set SIP informaon.
Click
Congure Congure serial No., IP address, gateway, subnet mask, password and No. of
the device.
Click Delete Delete the SIP Number.
Click Clear Clear all SIP numbers.
Click Refresh Refresh SIP Informaon.
Intercom Protocol
Steps
1.
Select Protocol as Private Protocol 1 or Private Protocol 2.
2.
Click save to save the
sengs.
Custom
Buon
Steps
1.
Click Custom
Buon to enter me parameters sengs page.
2.
Select Key Number as 1, 2, 3 or 4 depending on which buon you would like to custom.
3.
Congure dierent funcons for buons by selecng dierent Key Sengs.
4.
Oponal: Select Open in Screen Display Parameters area to display icons of Call Management
Center or Call Elevator on the menu.
Network Indoor Staon User Manual
53

HIKVISION KH6 Series Specifications

General

Brand	HIKVISION
Model	KH6 Series
Category	Control Panel
Language	English